Description
1967-1968 Ford Mustang
This dedicated tool is made from solid billet aluminum with a yellow anodized finish. Designed for removal and installation of 1967-68 Mustang ignition bezels without scratches caused by using a screwdriver. Our design allows for the use of a 7/8 or 22mm wrench if needed. Caution! Do not over-tighten! This may damage the tool and the bezel. Use firm pressure pushing the tool into the bezel while loosening or tightening with wrench. Hand tightening in most cases should be sufficient.
Specification:
| Brand | Scott Drake |
|---|---|
| Category | Vehicles, Equipment, Tools, and Supplies |
| Emission Code | 6 |
| Finish | Anodized |
| Material | Aluminum |
| part type | Ignition Switch Nut Tool |
| Product Type | Ignition Switch Nut Tool |
| Sub Category | Ignition Service |
| Warning | California Proposition 65 |
| Wrench Size | 7/8 |
